cheap Laptop Batteries,laptop ac adapter,Laptop accessories at MamBate

What's Include:

• Wireless Camera x 2
• Wireless Receiver x 1
• AC Adapter For Camera x 2
• AC Adapter For Receiver x 1
• Lithium Battery For Receiver x 1
• Video Cable x 1
• Earphone x 1

Installation:

1. Locate the camera to a desired position and then adjust it to a suitable angle.

2. Connect the adapter to the camera.

Tip:
After the camera is powered on, touch the pole once with finger(s) to turn on the baby lights; touch again to turn off it; hold the pole and the lights will blink.

3. Install the accompanying Li-batteries to the battery compartment with its polarities matched.

Note:

• This receiver can also be powered on by adapter.
• The Li-battery will be charged after the adapter is plugged in, and the charge indicator lights in red during charging and will turn off after a full charge.
• A full charge will take about 5 hours, which can power the receiverfor about 2 hours continuously.
• You are recommended to have the battery fully charged before its first installation to optimize its life.
• Do not burn or disassemble the Li-battery.
• Do not short-circuit the battery, it may cause fire or electric shock.

4. Slide the power switch to the ON position.

5. By pressing the channel button of the receiver to switch be the same channel of the camera, and then an image will appear on the screen.

NOTE:
Generally the channel of the camera is matched to the receiver at factory. If it isn't, follow the steps below:
1) By pressing the channel button on the receiver and the check code button on back part of the camera at the same time for about 5 seconds, the receiver will automatically switch to the same channel of camera.
2) An image will appear on the screen, means the two devices are now matched to each other.

6. Tune the volume control to a desired level.

NOTE: for more clear pictures, please connect the receiver to a monitor/TV with the supplied video cable.

Cautions:

• The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.
• Turn off the camera/receiver if the system is not in use.
• The camera/receiver can only be completely disconnected from themains by unplug the adapter.
• Do not cut the DC power cable of the apparatus to fit with another power source.
• Attention should be drawn to the environment aspects of battery disposal.

FCC information:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference.
(2) this device must accept any interference received, including
interference that may cause undesired operation.Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment.